Vivedino Core XY Flying Print 3D Printer
$2,158.65 – $2,698.65
- Core XY Motion System
- 300*300*400mm/400*400*500mm Build Size
- 32 Bit Controller with TMC2660 Driver
- Linear Guide Rails & Gates Belts
- Dual Gear Extruder
- Filament Runout Sensor
- Power Loss Recovery
- Magnetic Flexible PEI Sheet
- Auto Bed & Gantry Leveling
- Wirelessly Control via Wifi Module
- KEENOVO Heating Pad with SSR
- 4.3″ Touch Screen
- HEPA Air Filtration
- RGB Status Indicator Light
- Genuine Meanwell Power Supply
Vivedino Core XY Flying Print 3D Printer
-
Top Features:
Core XY Motion System
300*300*400mm/400*400*500mm Build Size
32 Bit Controller with TMC2660 Driver
Linear Guide Rails & Gates Belts
Dual Gear Extruder
Filament Runout Sensor
Power Loss Recovery
Magnetic Flexible PEI Sheet
Auto Bed & Gantry Leveling
Wirelessly Control via Wifi Module
KEENOVO Heating Pad with SSR
4.3″ Touch Screen
HEPA Air Filtration
RGB Status Indicator Light
Genuine Meanwell Power SupplyTroodon comes fully assembled, easy to use, the best choice for beginners.
Specification: Vivedino Core XY Flying Print 3D Printer
|
6 reviews for Vivedino Core XY Flying Print 3D Printer
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review

Vivedino Core XY Flying Print 3D Printer
$2,158.65 – $2,698.65
Customer –
Good customer support, fast delivery, printer is amazing. Worth every penny!
S***s –
All the best, the printer makes a very good impression The vivedino support is super.
C***e –
It was wat I payd for
A***y –
Plugged in 3 wires, did up 12 screws, Setup all done. Turned it on and got a perfect print on the first try with NO messing around.
N***r –
It was a bit of an Odyssey, ordered in April, received yesterday. The problem was the fu… virus. But what you need in this case is a store that offers good support. And Vivedino offered more than that. They tried everithing to get the machine to me and finally they got it. The response from Vivedino was always very fast and courteous. Many Thanks to the guys from Vivedino!!! The printer itself is easy to setup and built very nice. I like the RepRap Firmware with the web interface where you can do everithing you want. You can even make firmware changes without flashing the new firmware, just restart the printer. The print quality is outstanding even if you print really fast. 90mm/s is absolutely no problem for this machine. I printed the demo file of the SD card with 150% speed factor and it looks gorgeous. The only minor issue for me is the hotend, I don’t like the hotends with the PTFE tube down to the nozzle. It works just fine atm, but I will replace it with a dragon hotend.
Customer –
Great printer, linear rails are very accurate. Has a duet wifi inside and prints really well and fast.